What is ip route in Linux?

In Linux, ip command is used to show or manipulate routing, devices, policy routing and tunnels. ip route is a part of ip command. It helps to manage the route entries in the kernel routing tables that keep information about paths to other networked nodes. The routes can be set for different IP addresses (destination).

Which commands can be used to view a routing table?

You can display the routing table using the netstat -rn command or the route -s command.

What information will the command ip route show provide?

On a Cisco router, the show ip route command is used to display the IPv4 routing table of a router. A router provides additional route information, including how the route was learned, how long the route has been in the table, and which specific interface to use to get to a predefined destination.

How do I find my IP route table?

Use the show ip route EXEC command to display the current state of the routing table.

Where are ip routes stored Linux?

In all Linux and UNIX systems, the information about how the IP packets should be routed is stored in a kernel structure. These structures are called routing tables. If you want your system to communicate with other computers, you may want to configure these routing tables.

Where are IP routes stored Linux?

What command would you use to display the route table?

Where are routing tables stored?

RAM
A routing table is a table or database that stores the location of routers based on their IP addresses. This table acts as an address map to various networks, and is usually stored in the RAM of most routers or forwarding devices.

What is metric in ip route?

A metric is a value that’s assigned to an IP route for a particular network interface. It identifies the cost that’s associated with using that route. For example, the metric can be valued in terms of link speed, hop count, or time delay.