How much does it cost to put up a light pole?

The average street light pole cost ranges from $2,000 to $3,000, not including installation. The installation cost depends on the city, but the average is somewhere around $1,000. Street light poles are more complicated to install and considerably larger.

What are pole lights called?

A street light, light pole, lamppost, street lamp, light standard, or lamp standard is a raised source of light on the edge of a road or path.

How do you install a lamp post without concrete?

How to Install a Lamp Post Without Concrete

1. Dig a hole that is 18- to 24-inches deep and 6 inches in diameter.
2. Clear out rocks and loose dirt clods as you go.
3. Place the post in the hole you just dug.
4. Add a 1-inch layer of dirt to the hole.
5. Repeat this process until wet dirt begins to cover up the top layer of gravel.

How high should a pole light be?

The average height for a street light pole is between 9 and 14 feet. But there are also smaller ones ranging from 5 to 6.5 feet. These are mainly used in pedestrian areas rather than on roads.

How much is a power pole cost?

VERY rough numbers – commonly about $5-10/LF for overhead runs (meaning new poles typically every 100-300 feet, possibly more in high tree area), plus $500-3000 per pole needed depending on length (probably about 36-40′ tall minimum for your area if not rural but can be much more in heavily treed areas, so closer to …

How much electricity does a pole light use?

Light pole is 30 feet long. Most of the time, street lights are used for 12 hours a day. The average price in the USA is 10 cents per kilowatt-hour ($0.10/kWh). Consumption for 12 hours is (12 hours*100 watt) = 1200 watt-hours = 1.2 kWh.

How do you install an outside pole light?

Step-By-Step Guide in Installing an Outdoor Post Lamp

1. Step #1: Dig the posthole and trench.
2. Step #2: Install the PVC conduit.
3. Step #3: Fill the posthole with concrete.
4. Step #4: Set the post into the concrete footing.
5. Step #5: Install the lamppost.
6. Step #6: Brace the lamppost perfectly plumb.
7. Step #7: Make the wire connections.

How long is a street light pole?

In most cases, street pole heights range from 9 to 14 feet. Ideally, the street light pole should provide sufficient light without there being an excessive glare. Although they help fight crime, street lights are meant to illuminate the way for pedestrians, cyclists, and motorists.

What does a power pole cost?

With an average installed cost per pole of $3000, the total installed cost is $63 million per 1000 miles. Typically around 12% of these poles are inspected every ten years at an inspection cost of approximately $100 per pole using third-party inspectors.

How long do light poles last?

Most power poles are much older than their useful life expectancy, which is likely somewhere around 50 to 60 years. But some of them are much older. Metal and concrete poles can last much longer than wood, but eventually all utility poles need to be replaced.

How much does it cost to leave an outside light on all night?

A “normal” incandescent bulb costs about 0.75cents per hour, and LEDs or CFLs cost only one-sixth of that – so leaving the lights on (either overnight or while you’re at work for the day, say both are about 8 hours) costs you roughly 6 cents for a normal light and a bit over 1 cent for modern bulbs.

What is the point of purple street lights?

A sampling of social media comments highlights the range of reactions: One person said the purple hue gives them headaches due to a past concussion. Another thought it some sort of black light. Fans said it is easier on the eyes while driving or just enjoyed seeing something a little different.

Why are they installing purple street lights?

“It’s an issue with the filters.” Each streetlight comes with three filters that are red, yellow and blue, the primary colors. The yellow filters will sometimes malfunction, and the leftover filters will create a purple tint.

How deep do you bury a light pole?

Calculating the Depth of the Pole Poles are typically set into the ground: 10% of the overall height + 2 feet, except in questionable soil conditions. Example: Overall pole height: 30 feet, the pole should be buried: 3 feet + 2 feet = 5 feet below grade, and 25 feet above grade.