How do I reset my lap1142n e K9?

To reset the AP, try these steps: Step 1 Disconnect power from access point. Step 2 Press and hold MODE button while you reconnect power to the access point. Step 3 Hold the MODE button until the status LED turns amber, and release the button.

How do I reset my air cap3502i e K9?

How to factory reset (hard reset) Cisco AIR-CAP3502E-A-K9 :

1. When the router is on, press the button reset and hold for 30 seconds.
2. While holding down the button reset, turn off the power of the router and hold down the button reset for 30 seconds.

How do I reset my Cisco 1142 to factory settings?

Factory Reset via MODE Button Press and hold the MODE button while you reconnect power to the access point. Hold the MODE button until the Status LED turns amber (approximately 1 to 2 seconds), and release the button.

How do I reset my air cap1702i e K9?

Power up AP, hold mode button for 30 seconds, remove power and continue to hold mode button for 30 seconds, provide power again and continue to hold mode button for another 30 seconds.

How do I reset my air cap3702i e k9?

This is a standard process that works for me on some other models. 2.) I also tried the 30-30-30 process. Power up AP, hold mode button for 30 seconds, remove power and continue to hold mode button for 30 seconds, provide power again and continue to hold mode button for another 30 seconds.

How do I reset my Cisco Air AP1242AG a K9?

How to factory reset (hard reset) Cisco AIR-AP1242AG-A-K9 :

1. When the router is on, press the button reset and hold for 30 seconds.
2. While holding down the button reset, turn off the power of the router and hold down the button reset for 30 seconds.

How do I Reset my Cisco Air lap1242ag e K9?

How do I Reset my air cap3702i e K9?

How do I Reset my Aironet 1142n to factory default settings?

You can reset your Aironet 1142N to factory default by 2 methods The first method is to remove the power (adapter or the ethernet adapter when the device get its power by PoE) Press the mode button and reconnect the power. Hold the mode button for at least 2 seconds when its powering on.

Can an air-lap1142n-e-k9 be deployed in a H-reap setup?

07-06-2010 12:02 AM We have an AIR-LAP1142N-E-K9 deployed in a H-REAP setup. This AP already got the configuration from the WLC when it was deployed at a remote site.

Does air-lap1142n-e-k9 have CAPWAP debug messages on WLC?

We have an AIR-LAP1142N-E-K9 deployed in a H-REAP setup. This AP already got the configuration from the WLC when it was deployed at a remote site. Now we moved it to another site, but it doesn’t appear in the WCS and i don’t see any CAPWAP debug messages on the WLC.