What size air compressor do I need for HVLP?

HVLP guns require plenty of air, so you need to have a larger capacity compressor higher than those used for diy home works. In order to spray the full range of finishing products, however, you need at least a 21⁄2 to 3 HP compressor with a 75 liters (20 gallons) tank.

Is a HVLP paint sprayer worth it?

The benefits of HVLP sprayers are that they can atomize paint faster, more accurately, and at a lower pressure than traditional paint guns, creating a softer, more even spray—so you can cover larger areas faster without as many touchups. Plus, the lower pressure also minimizes air pollution.

How much psi do you need to run a HVLP spray gun?

The HVLP spray gun resembles a standard spray gun in shape and operation. Models that use high inlet pressure (20- 80 psi) and convert to low pressure internally within the spray gun are called HVLP conversion guns.

Can I use HVLP gun with small compressor?

The Neiko 31215A Gravity Feed HVLP Air Spray Gun works great with a small air compressor for a smooth, professional finish. Please note that the working pressure of the Neiko 31215A Gravity Feed HVLP Air Spray Gun is rated at 40 PSI, with a working pressure of 10 PSI.

What causes orange peel HVLP?

With the newer water-based materials orange peel is usually a result of spraying on too thick of a film. Try spraying an extremely THIN FILM, but still WET coat. A wet coat being “no dry spots that you think will flow together” and at the other end “no puddles or runs”.

How much psi do I need to paint a house?

Setting the air pressure to about 28-29 PSI for clear will ensure you having great flow out. Most HVLP spray guns will use 10-14 scfm at 40 psi. This is volume of air pressure per cubic foot.

Can I paint a car with a 6 gallon air compressor?

Painting a Car – What Size Air Compressor To Paint Your Car? It’s recommended to pick yourself up a 60 Gal tank with a 5-6 HP compressor that put’s out enough CFM that will supply your spray gun. Look for CFM in the ranges of 14-18 at 90PSI. This is what I have setup at the LABAP shop.