How do you enter Rommon on a router to do a password recovery?
How do you enter Rommon on a router to do a password recovery?
Press break on the terminal keyboard within 1 minute of power up in order to the router into ROMmon. Enter in confreg 0x2142 at the rommon 1> prompot in order to boot the from Flash. Type reset at the rommon 2> prompt. Type no after each setup question or press Ctrl+C to bypass all questions.
How do I reset my Cisco Rommon password?
Place the router in ROM Monitor (ROMMON) mode.
- Set the RP configuration register to 0x42 at the ROM.
- The configuration register is not an environment.
- The router password is recovered successfully.
How do you enter Cisco Rommon?
To manually boot into the ROMmon mode, you will need to reboot the device and break the boot sequence. Pressing the Ctrl+Break key combination during boot usually does this.
What is break sequence for cisco?
Standard Break Key Combinations
| Software | Platform | Try This |
|---|---|---|
| Telnet | N/A | Ctrl-], then type send brk |
| Telnet to Cisco | IBM Compatible | Ctrl-] |
| Teraterm | IBM Compatible | Alt-b |
| Terminal | IBM Compatible | Break |
How do I access Rommon?
How do I Reset my Cisco 7200 router?
Reset Router to Default Configuration
- With the router powered off, connect the power cord to your router, and plug the power cord into your power source.
- Find the Reset button on the router.
- Press and hold the Reset button while you power on the router.
- Release the Reset button after 10 seconds.
How do I restore my Cisco router from Rommon mode?
Reload, initialize, or power cycle the router with the configuration register boot field set to 0. Reload, initialize, or power cycle the router without having a Cisco IOS Software image to boot from. Press the Break key within the first 60 seconds of the system boot. The break function is enabled during this period.
Which of the following key is used to enter into router recovery mode while booting?
Boot the router and interrupt the boot sequence by pressing Ctrl + Break key combination.
How do I reset my Cisco 1941 to factory settings?
Find the Reset button on the router. Press and hold the Reset button while you power on the router. Release the Reset button after 10 seconds. Wait 5 to 10 minutes for the router to finish booting.