How do you build a Rodinal?

To develop our film we’ll use the RODINAL developer (also know as R09 or ADONAL)….Wash the film with clear water for 5 minutes or use the following method :

1. Put clean water in the tank and do 5 inversions.
2. Change the water and do 10 inversions.
3. Change again the water and do 20 inversions.

How do you do stand development?

Stand Develop Your Film Agitate by turning the tank upside down, then back up again. Once the minute is up bang the bottom of the tank against a hard surface. This will dislodge any air bubbles that have built up on the film. Now simply leave it to stand for an hour.

What is a compensating developer?

A compensating developer is one which compresses highlight density range. Or iow, rather than a straight-line response of increasing density with increasing exposure, a compensating developer provides less and less density increase per unit of exposure.

What is stand initiation?

Stand Initiation (Reorganization) Stage. • After a lethal disturbance creating a chunk of vacant. growing space, the trees that may become established do. not fully occupy the growing space (before canopy closure).

How do you stand develop with HC 110?

Stand Developing With HC-110

1. Presoak the film for 5 minutes in water at 68 degrees.
2. Mix 6mL HC-110 syrup with 714ml water at 68 degrees (720mL working solution)
3. Gentle agitation for the first 30 seconds and then let it set for 30 minutes.

How do you agitate Rodinal?

You could try stand development. Rodinal at 1+100 for about 45 minutes to 1 hour. Agitate initially as directed, then leave it be for the remainder. Rinse, fix, and wash as usual.

How many times can you reuse Rodinal?

1 Answer. Show activity on this post. Adox Rodinal is a one shot developer, meaning it is not meant to be reused (https://www.adox.de/Photo/adox-film-developer/rodinal-adonal/). Mix up your 1+50 for your immediate needs and discard when done developing.

Is hc110 a compensating developer?

HC-110 as a compensating developer | Photo.net Photography Forums.

What is compensating developer in photography?

What are the 4 stages of stand development?

After disturbances, forests develop through general physiognomic stages: “stand initiation”, “stem exclusion”, “understory reinitiation”, and “old growth”.

Why is stand development important?

These structures are important because the different structures provide habitats for different species; different susceptibilities to winds, fires, insects, and other disturbances; different volumes and qualities of timber; and differences in other values.

What is bromide drag?

Bromide drag lines are a byproduct of development with no agitation. High concentrations of bromide is produced around the perforations and overexposed areas. Without agitation it slowly slides down the surface of the film, inhibiting development and creating drag lines.

What happens if you over agitate film?

If you’re worried about messing up your film because of too much or too little agitation, in general, the effect of missing one or two inversion or agitation cycles won’t make a major impact on the results of your film.